Range approximately 0.three weight, which can be connected for the evaporation of water. At MCC950 NOD-like Receptor temperature approximately 0.three weight, that is connected towards the evaporation of water. At aatemperature from 30 to 1000 having a temperature boost price of ten /min in air with a gas flow of about 350 , peak was noticeable, which may perhaps have resulted from the transformation of of about 350 C, a a peak was noticeable, which may possibly have resulted from the transformation rate of one hundred cm3/min. As much as a temperature of roughly one hundred , the fly ash sample lost of Fe compounds. The was was observed at a temperature of about C and and correFe compounds. The peakpeak seen at a temperature of about 5800058000 corresponded roughly 0.three weight, which is connected towards the evaporation of water. At a temperature sponded to the of -quartz to -quartz to -quartz as well as the reaction among unreacted for the conversion conversion of -quartz along with the reaction involving unreacted particles and of about 350 , inside the was noticeable, which may well have resulted from the transformation activator trappeda peak pores. Decomposition of aluminum hydroxide (Al(OH)three )hydroxide particles and activator trapped inside the pores. Decomposition of aluminum also took of Fe compounds. The peak was seentemperatures of 700 about 58000 and correat a temperature of endothermic spot in the also took place in variety. At temperature range. C, temperaturesor exothermic (Al(OH)three) exact same temperature exactly the same At of 700 , ensponded occurred, which correspondedto -quartzcorresponded towards the decomposition of for the conversion of -quartz to the decomposition of CaCO , Ti(OH) and reactions or exothermic reactions occurred, which as well as the reaction in between unreacted dothermic 3 four particles .and activator trapped in about 900 Decomposition for the crystallization in the pores. Mg(OH)Ti(OH)exothermic effect at exothermic C may be relatedof aluminum hydroxide CaCO3, 2 The four and Mg(OH)two. The impact at about 900 may be related to the (Al(OH)3) also phases. Observed modifications have been related to those presented in [49] to get a enamorphous C2 Ceramide References ashtook spot inside the exact same temperature range. At temperatures of 700 ,precrystallization of amorphous ash phases. Observed modifications were equivalent to these dothermic or geopolymer. At a temperature of as much as 900 C, the lossthe the sample mass exothermic reactions occurred, which corresponded to of decomposition of fly ash-based to get a fly ash-based geopolymer. At a temperature of up to 900 , the loss sented in [49] CaCO3, Ti(OH)4 and Mg(OH)two. stripping of volatile parts. At 900 might be associated tothe (upthe6.51 ) was associated to the The exothermic effect at about temperatures above temperof to sample mass (as much as six.51 ) was associated towards the stripping of volatile components. At 900 C, crystallization of amorphousthe flyweresample and more than 1 of its lost to thosetotal coal residues have been , coal residues phases. Observed modifications have been similar far more than 1 atures above 900 burnt, and ash ash burnt, lost the fly ash sample weight. The presented loss was 8.7 in ash-based geopolymer. At a DTG analysis of up to 900 , the the for temperature also showed that in loss weight in [49]The a fly fat loss was 8.7 within the temperature range. The DTG evaluation of its weight. total this temperature variety. this on the the tested ash, the mass loss through heating was steady, and the greatest amplitude mass (up the stripping At case of samplethat in theto 6.51 ) was associated towards the mass loss of volatile components.wastemperalso showed c.